Diamond Works

User friendly, low odor, easy to spread, easy to strip, long service life. 20% non volatile (solids) Dries thicker than an 18% solids finish. Five coats at 2000 sq.ft./gallon per coat (50 sq.m/Liter), will be 1/1000 of an inch thick (= 25 microns), the threshold of durability. Directions for Vinyl Composite Tile (VCT) No sealer needed when applied directly to VCT. Note: always remove the original “factory” coating from new VCT before applying this product. Periodic use of mop-down restorer or liquid spray buff will increase gloss and prolong interval between recoats. Scrub and Recoat of Existing Finish Since old finish acts as sealer, no new sealer is required. Our coatings normally display high gloss when applied over top of any well-cured finish, regardless of brand, subject to the following guidelines: The old finish should be thoroughly wet-scoured using recommended HYDROFORCETM or TURBOFORCETM deep-scrub solutions using a red, blue, or green scrubbing pad, depending upon soiling. Remove all dust and oil to promote proper leveling. Do not burnish after deep-scrubbing and do not burnish between re-coats. Health and Environment Contains no APEOs which may become environmental hormones. Contains no PFOS based fluorosurfactant and less than 10 grams of reportable VOC per Liter. Complies with CARB 2010. Eligible for LEED credits.